KIT special configuration files

These are special configuration files for OpenVPN at KIT. The default configuration files, best for most use cases, are at the beginning of the instruction page for the respective operating system. The configuration #1 on this page ist also the respective default config (using port 1194).

All configuration files can also be found in the git repository kit-openvpn-client-conf.

KIT default vpn

#1 IPv4-Connect (l3, udp):		Port:
#2 Split IPv4-Connect (l3, udp):		Port:
#3 IPv6-Connect (l3, udp):		Port:
#4 Split IPv6-Connect (l3, udp):		Port:
#5 IPv4-Connect TCP (l3, tcp):		Port:
#6 IPv4-Connect UDP Lower MTU (l3, udp):		Port:

KIT VPN2VLAN

there's no extra configuration file for split (is controlled by realm)

#1 IPv4-Connect (l2, udp):		Port:
#2 IPv6-Connect (l2, udp):		Port:
#3 IPv4-Connect TCP (l2, tcp):		Port:
#4 IPv6-Connect TCP (l2, tcp):		Port:
#5 IPv4-Connect UDP Lower MTU (l2, udp):		Port: